It’s winter, but you decide you want to start a garden. You don’t have to wait until the ground thaws to start your spring garden.
Prepare a jumper wire approximately 8in long with a male quick disconnet terminal at one end and a test probe at the other end. Disconnect
Here’s a step-by-step to figure out the issue and fix it. Determine the unit has fuel. If the flame is present skip to step 6.
Remove the photocell from the heater and connect an ohmmeter on the 1000 OHM(RX1k)scale. Hold the lens up to a light source like an 80
Tools Required:5/16″ Nut Driver, #2 Phillips Screwdriver, Feeler Gauge, 0-15lb Pressure Gauge, Straight Blade Screwdriver Unplug heater Remove upper shell and plastic fan grill(if equipped)
Problem: The motor binds after replacing the rotor. Reason: Oversized Rotor or improper rotor gap. If the fan is hard to turn when the motor
Air pump pressure is directly related to fuel delivery. If the pump pressure is incorrect, the fuel delivery will be incorrect. As a result the
table> Model Motor Transformer/ Ignition Control/ Ignitor Safety/Flame-Out Control Fan Relay Spark Plug/ HSI Filter Kit Nozzle Photo Cell Rotor Kit, Rotor, Blades, Insert B30
Model Motor Microprocessor Control Ignition Module Kit Ignitor Electrode Filter Kit Nozzle Photocell Roter Kit TA100 NA 117766-01 NA NA PP213 100735-35 M16656-26 PP204 TA103